HD-606 Mite adjuvant

DESCRIPTION

HD-606 is a synergist specially used to kill mites alone. The aqueous solution of the additive has low surface tension, can reduce the contact angle between the liquid surface and the medium, so that it can completely cover the front and back of the crop leaf surface, increase the solution's all-round coverage of the mites, and efficiently kill the mites. The auxiliary agent contains active factors with strong penetrating effect, and can be used together with acaricide preparations to improve the killing power of the medicament against insect eggs.

Performance and use

1 Single kill mites: can be used alone to kill citrus mites;

2 Fast results: After the spray water evaporates quickly, the mites die immediately;

3 High mortality rate: the mortality rate of mites is higher than 95%;

4 Promoting absorption: It can promote other acaricides to penetrate the entire plant through the stomata, speeding up the absorption of the liquid

5 Strong wetting: excellent spreading and wetting ability, full coverage of the front and back of the leaves, leaving no dead corners;

6 No resistance: physical insecticide mode is adopted to make the mites less likely to develop resistance;

7 Easy to mix: It can be compounded with a variety of pesticide formulations, it is not easy to flocculate with the liquid, and can be used in a variety of environments;

TYPICAL PROPERTIES

Viscosity (25℃), mm2/s

40-100

Appearance

Light yellow transparent liquid

Surface tension (0.1% aqueous solution), mN/m

≤22.0

Density (20℃), g/cm3

0.9-1.1

pH range (1.0% aqueous solution)

6.0-8.0

USES AND APPLICATION

Usage 1: Dilute the additive separately 2000 to 3000 times, and spray it to kill mites directly after mixing.

Usage 2: After mixing other acaricides with water according to the use multiple, add the corresponding amount of the auxiliary agent according to the 2000-3000 dilution multiple, and spray after mixing.

Precautions

1 HD-606 is not easy to mix with acidic or alkaline pesticides.

2 It is not easy to mix with methacrylate and other hypertonic pesticide products (it is strictly forbidden to use this product with pesticides that cannot be mixed with silicone), such as azoxystrobin, pyraclostrobin, etc.

3 It is not allowed to add high penetration additives after adding this product.

4 It is forbidden or used with caution during flowering, young fruit, and tender leaves.

5 It is ready to use, the spray liquid needs to be used on the same day, and the effect is better.

6 This product is non-toxic. If accidentally splashed on the eyes or skin, rinse with water, keep 7 it out of the reach of children and do not eat it.

Packaging, storage and transportation

H-606 can be used in 200L drums and 1000L IBC drums or others, stored in a cool, ventilated, dry place, with a shelf life of 3 years (unopened), and transported as a non-hazardous chemical.

Link to this article:HD-606 Mite adjuvant

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting.:Silicone And Casting,Thanks!^^


Related Posts