Test preparation and operation

Prior to beginning a test, make certain that most circumstances are optimized.
Air heat at the hopper gate
Examine the dryer for appropriate:
Hopper capability relative towards the dimension of test to be dried
  Dew point from the drying air
  Examine the refrigerator and thermolator.
Airflow
  Clear the hopper and material-maneuvering method thoroughly.
En sure appropriate custom mold heat management is accessible.
Be certain the molding machine is clear. (See the area on start-up and purging.)
Confirm test objectives. The aim from the test dictates the quantity of polymer required and also the good quality and amount of components needed . For instance, in case the purpose is to acquire 6 excellent components for testing, it’s typical to operate 201 shots upon an untried custom mold. In case the purpose is to create 51 components, minimize cycle,or examine aspect variability, the quantity of polymer and time needed could be greatly greater.

It’s essential to keep a total record of operating circumstances,pretrial preparations, modifications,etc.throughout the test. Forms for documenting test procedures are furnished for your benefit.Completing Shape ensures that most required basic procedures are already performed.Shape Identifying difficulties that are causing scrap,which can be utilized throughout the molding test. Changes created to running variables and results of those changes throughout the test or start-up can be recorded on another Shape .
Retain 31- to 61-g (1.1 to 2.1oz) samples from the pellets and components for follow-up trials of Ih.V. (inherent viscosity) or molecular mass.
Document and save most setup circumstances, changes to circumstances,and their results on aspect good quality. Add comments concerning what proved helpful and what caused difficulties. Offer copies to most test staff and to your Plastic material supplier.While the task goes to manufacture, give replicates to most persons concerned.

Start-up
Begin with a clear machine. In case the equipment is not cleared,unmelted item, gaseous splay, or a mixture of difficulties will outcome. Ball checks are usually slow to purge and customarily are not advised; examine rings are favored.Removing and washing the screw, examine valve, nozzle, as well as barrel are definitely the simply efficient methods of purging difficult-to-reduce high-temperature polymers.

Purge materials
The polymer most efficient in purging is usually a polymer comparable to the polymer to be operate. PE and PP should
be ignored simply because they can mix using the latest polymer and result in streaks for prolonged time periods. For difficult-to-take away materials, nozzle and front side barrel sector setpoints are occasionally improved about 300 C (570 F) to soak and clear,subsequently cooled down backside to operating temperatures. Make use of caution and consider the manufacturer??£¤s advice for the polymer utilized within the previous operate. After any cycle disruption of over roughly 5 minutes, purging 35 shots is excellent exercise.

Link to this article：test preparation and operation

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting.：Silicone And Casting，Thanks！^^