Clear silicone sealant has been used for several years to close windows and doors after installation. It is just a good product to use when waterproofing an undertaking. It isn’t challenging to use, and, using easy steps, you may find that you’ve be a pro. Remember, though, that silicone sealant bring various applications that require a definite, waterproof seal. Instructions 1. Insert the clear silicone sealant into the caulking gun. The caulking gun can be a round, metal cylinder that may get a tube of silicone sealant. It has a metal rod inside that pushes through the rear in the tube of silicone sealant and forces the sealant away from an advice on no more the silicone tube. By pressing a handle on no more the caulking gun, you’ll be able to control the volume of silicone that is dispensed. 2. Silicone TubeTrim a smaller piece (about 2 inches long) off the Plastic tip located after the sealant tube. The tube is approximately 1/8 inch wide in the very tip, plus it flares over to 1/2 inch at where it attaches to the cylinder of sealant. Begin with a tiny piece and then come up to the desired hole size as you need to. 3. Poke a protracted nail up through end of the tip and pierce the foil seal located in the tip possibly at the foot of the sealant tube.4. Press leading against the place to be sealed and gently squeeze the handle located near the top of the caulking gun. An individual will be finished with the applying, release the pressure in the caulking gun by disengaging the metal rod at the handle. Failure to do this will lead to sealant leakage. 5. Smooth the bead of silicone sealant out with your finger. Cleanup any excess silicone having a rag and paint thinner